1993 Jeep Cherokee Recall Mar 09, 1993 | The Tire And Wheel Specification Information On The Certification Label Indicates A

1993 Jeep Cherokee Equipment,other,labels Recall | Mar 09, 1993

The Tire And Wheel Specification Information On The Certification Label Indicates A Minimum Tire Size Larger Than The Tire Actually Fitted To The Vehicle. This Does Not Comply With Fmvss 120, “tire Selection And Rims.”

Installation Of The Wrong Size Tires To The Rim Could Result In Loss Of Vehicle Control.

Summary Of Corrective Actions Taken: Provide Correct Certification Labels To Vehicle Owners For Application To The Vehicles.

System: Tire Certification Labels; Fmvss 120.vehicle Description: Utility Vehicles With 4.0 Liter Engines.

This recall was issued on Mar 09, 1993 for 1993 Jeep Cherokee, manufactured by CHRYSLER CORPORATION, in response to Equipment,other,labels problems.

1993 Jeep Cherokee Recall Sept 27, 1993 | The Two Rear Inboard Safety Belt Attachment Bolts May Have Inadequate Thread

1993 Jeep Cherokee Seat Belts,front,anchorage Recall | Sept 27, 1993

The Two Rear Inboard Safety Belt Attachment Bolts May Have Inadequate Thread Engagement Into The Floor Pan Anchor Nuts.

The Safety Belt Attachment Bolts May Not Support Theload Of Rear Seat Passengers In The Event Of A Sudden Stop Or Accident; Theassembly Fails To Comply With The Static Load Requirements Of Fmvss 210, “seatbelt Assembly Anchorages.” The Inability To Support The Load Of Rear Seatpassengers Increases The Risk Of Injury To Seat Occupants.

Summary Of Corrective Actions Taken: Replace The Two Inboard Safety Belt Anchor Bolts With Longer Bolts On All Vehicles.

System: Interior Systems: Restraint Safety Belt Anchor And Attachment/ Fmvss 210vehicle Description: Multi-purpose Passenger Vehicle.note: If You Have Any Problem Obtaining The Needed Repair, Please Contact Thechrysler Zone Service Office In Your Area. (it Is Listed Under “serviceassistance” In Your Owner’s Manual.) A Zone Representative Will Arrange Forprompt Attention To Your Vehicle. Also, Please Contact The National Highwaytraffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on Sept 27, 1993 for 1993 Jeep Cherokee, manufactured by CHRYSLER CORPORATION, in response to Seat Belts,front,anchorage problems.

1993 Jeep Grand Wagoneer Recall Dec 13, 1993 | The Molded Plastic Pin Which Connects The Upper Steering Column Shaft And

1993 Jeep Grand Wagoneer Steering,wheel And Handle Bar Recall | Dec 13, 1993

The Molded Plastic Pin Which Connects The Upper Steering Column Shaft And The Lower Column Shaft May Have Been Sheared Prior To Installation Of The Steering Column Assembly Into The Vehicle. If This Occurred, The Upper Steering Shaft Will Separate From The Lower Steering Shaft.

If The Upper And Lower Steering Shafts Separate, Completeloss Of Steering Control Will Occur, Which Could Result In An Accident.

Summary Of Corrective Actions Taken: A Restraining Sleeve Will Be Added To The Intermediate Shaft To Limit The Amount Of Steering Shaft Movement Available.

System: Steering; Column Shaft; Upper.vehicle Description: Multipurpose Passenger Vehicles.note: If You Have A Problem Obtaining The Needed Repair, Please Contact Thechrysler Zone Office In Your Area. It Is Listed Under “service Assistance” Inyour Owner’s Manual. A Zone Representative Will Arrange For Prompt Attention Toyour Vehicle. Also Contact The National Highway Traffic Safety Administration’sauto Safety Hotline At 1-800-424-9393.

This recall was issued on Dec 13, 1993 for 1993 Jeep Grand Wagoneer, manufactured by CHRYSLER CORPORATION, in response to Steering,wheel And Handle Bar problems.

1993 Jeep Grand Cherokee Recall Dec 13, 1993 | The Molded Plastic Pin Which Connects The Upper Steering Column Shaft And

1993 Jeep Grand Cherokee Steering,wheel And Handle Bar Recall | Dec 13, 1993

The Molded Plastic Pin Which Connects The Upper Steering Column Shaft And The Lower Column Shaft May Have Been Sheared Prior To Installation Of The Steering Column Assembly Into The Vehicle. If This Occurred, The Upper Steering Shaft Will Separate From The Lower Steering Shaft.

If The Upper And Lower Steering Shafts Separate, Completeloss Of Steering Control Will Occur, Which Could Result In An Accident.

Summary Of Corrective Actions Taken: A Restraining Sleeve Will Be Added To The Intermediate Shaft To Limit The Amount Of Steering Shaft Movement Available.

System: Steering; Column Shaft; Upper.vehicle Description: Multipurpose Passenger Vehicles.note: If You Have A Problem Obtaining The Needed Repair, Please Contact Thechrysler Zone Office In Your Area. It Is Listed Under “service Assistance” Inyour Owner’s Manual. A Zone Representative Will Arrange For Prompt Attention Toyour Vehicle. Also Contact The National Highway Traffic Safety Administration’sauto Safety Hotline At 1-800-424-9393.

This recall was issued on Dec 13, 1993 for 1993 Jeep Grand Cherokee, manufactured by CHRYSLER CORPORATION, in response to Steering,wheel And Handle Bar problems.

1993 Jeep Grand Wagoneer Recall Apr 08, 1993 | Grease Applied To The Liftgate Latch Rubber Bumpers To Ease Component Assembly

1993 Jeep Grand Wagoneer Structure,body,hatchback/liftgate Recall | Apr 08, 1993

Grease Applied To The Liftgate Latch Rubber Bumpers To Ease Component Assembly Caused The Bumper To Swell, Interfering With The Movement Of The Liftgate Latch Pawl. This Prevents The Liftgate Latching When Closed And Difficult To Open When Latched.

An Unlatched Liftgate Can Open While The Vehicle Is Inmotion, And Could Result In An Occupant Falling Out.

Summary Of Corrective Actions Taken: Replace The Liftgate Assembly On Affected Vehicles.

System: Structure; Lift Gate.vehicle Description: Utility Vehicles; Model Grand Cherokee And Grand Wagoneer.

This recall was issued on Apr 08, 1993 for 1993 Jeep Grand Wagoneer, manufactured by CHRYSLER CORPORATION, in response to Structure,body,hatchback/liftgate problems.

1993 Jeep Grand Cherokee Recall Apr 08, 1993 | Grease Applied To The Liftgate Latch Rubber Bumpers To Ease Component Assembly

1993 Jeep Grand Cherokee Structure,body,hatchback/liftgate Recall | Apr 08, 1993

Grease Applied To The Liftgate Latch Rubber Bumpers To Ease Component Assembly Caused The Bumper To Swell, Interfering With The Movement Of The Liftgate Latch Pawl. This Prevents The Liftgate Latching When Closed And Difficult To Open When Latched.

An Unlatched Liftgate Can Open While The Vehicle Is Inmotion, And Could Result In An Occupant Falling Out.

Summary Of Corrective Actions Taken: Replace The Liftgate Assembly On Affected Vehicles.

System: Structure; Lift Gate.vehicle Description: Utility Vehicles; Model Grand Cherokee And Grand Wagoneer.

This recall was issued on Apr 08, 1993 for 1993 Jeep Grand Cherokee, manufactured by CHRYSLER CORPORATION, in response to Structure,body,hatchback/liftgate problems.

1993 Jeep Wrangler Recall Sept 13, 1993 | Windshield Frame Metal May Crack At The Wiper Arm Pivot Mountings Due

1993 Jeep Wrangler Visibility,windshield Wiper/washer,linkages Recall | Sept 13, 1993

Windshield Frame Metal May Crack At The Wiper Arm Pivot Mountings Due To Metal Stress During Wiper Operation.

This Can Cause Dislocation And Binding Of The Wipersystem Linkage Which, In Inclement Weather, Could Affect Driver Visibility Andresult In An Accident.

Summary Of Corrective Actions Taken: Retrofit With A Windshield Frame Reinforcement At The Wiper Pivot Locations And Install New Redesigned Linkage Components To Reduce Stress At The Pivot Mountings.

System: Visual; Windshield Frame And Wiper Linkage.vehicle Description: Multi Purpose Vehicles.note: This Is A Continuation Of Nhtsa Recall 88v155000. The Manufacturer Beganincluding A Windshield Frame Reinforcement In Its Vehicle Production As Ofoctober 13, 1988. 1989 Models Produced Before October 13, 1988 Are Eligible Forthis Recall.

This recall was issued on Sept 13, 1993 for 1993 Jeep Wrangler, manufactured by CHRYSLER CORPORATION, in response to Visibility,windshield Wiper/washer,linkages problems.

1993 Jeep Wrangler Recall May 11, 1993 | Salt Corrosion Products Between The Starter Solenoid Wire And The Adjacent Battery

1993 Jeep Wrangler Electrical System,ignition,switch Recall | May 11, 1993

Salt Corrosion Products Between The Starter Solenoid Wire And The Adjacent Battery Feed In The Bulkhead Connector May Short These Connections, Causing The Circuit To Bypass The Ignition Key Control Of The Starter Motor Solenoid. The Car Can Start Without The Starter Sequence Being Initiated By The Ignition Key In The Ignition Lock.

The Unintended Start Of A Vehicle With A Manualtransmission Left In A Drive Gear Can Result In A Runaway Vehicle.

Summary Of Corrective Actions Taken: The Starter Solenoid Wiring Will Be Separated From The Battery Feed Wire By Relocating It Within The Bulkhead Connector On Affected Vehicles.

System: Ignition System.vehicle Description: Multi-purpose Passenger Vehicles Equipped With Manualtransmissions.

This recall was issued on May 11, 1993 for 1993 Jeep Wrangler, manufactured by CHRYSLER CORPORATION, in response to Electrical System,ignition,switch problems.

1993 Jeep Grand Wagoneer Recall Apr 02, 1993 | The Eccentric Cam Adjuster Bolts In Both Front Lower Suspension Arm-to-front Axle

1993 Jeep Grand Wagoneer Suspension,front Recall | Apr 02, 1993

The Eccentric Cam Adjuster Bolts In Both Front Lower Suspension Arm-to-front Axle Bracket Attachments May Fail Due To Assembly Misalignment.

Cam Bolt Failures Cause The Vehicle To Pull To Oneside When The Brakes Are Applied, Resulting In A Possible Loss Of Vehiclecontrol And An Accident.

Summary Of Corrective Actions Taken: Replace The Front Suspension Cam Bolts, Cam Washers, And Nuts With Components Of A Different Design.

System: Front Suspension.vehicle Description: Sport Utility Vehicles.

This recall was issued on Apr 02, 1993 for 1993 Jeep Grand Wagoneer, manufactured by CHRYSLER CORPORATION, in response to Suspension,front problems.

1993 Jeep Grand Cherokee Recall Apr 02, 1993 | The Eccentric Cam Adjuster Bolts In Both Front Lower Suspension Arm-to-front Axle

1993 Jeep Grand Cherokee Suspension,front Recall | Apr 02, 1993

The Eccentric Cam Adjuster Bolts In Both Front Lower Suspension Arm-to-front Axle Bracket Attachments May Fail Due To Assembly Misalignment.

Cam Bolt Failures Cause The Vehicle To Pull To Oneside When The Brakes Are Applied, Resulting In A Possible Loss Of Vehiclecontrol And An Accident.

Summary Of Corrective Actions Taken: Replace The Front Suspension Cam Bolts, Cam Washers, And Nuts With Components Of A Different Design.

System: Front Suspension.vehicle Description: Sport Utility Vehicles.

This recall was issued on Apr 02, 1993 for 1993 Jeep Grand Cherokee, manufactured by CHRYSLER CORPORATION, in response to Suspension,front problems.